The Nordin Titanium Retention Pins are machined out of a solid rod of premium pure titanium with the same precision smooth cut thread as a Swiss made watch which gives the pins maximum retention. The titanium pins are not merely a threaded wire pushed into a shaft, but they are machined out of a solid rod of premium pure titanium making them much better than any other titanium pins on the market at a fraction of the cost of market leaders.
Other benefits include
- Made from non-corrosive titanium material;
- Maximum retention
- Cut from solid rod
- Superior stability
Instructions for Use:
1)Drill hole in dentin where pin retention is desired avoiding closeness to pulp and outside of tooth;
2)Insert shaft of pin in standard contra angle;
3)Put point of pin at appropriate R.P.M. to pre-drill hole and pin will center into and penetrate to the bottom and automatically break off from shank; and
4)Pin can be bent with appropriate instruments if increased retention is desired.
Nordin Titanium Dentin Retention Pins Intro Kit (Part NMPK)
0.60mm, 12 Pins + 1 Drill
Nordin Titanium Dentin Retention Pins Refill (Part NMPR)
0.60mm, 100 Pins + 4 Drills
Write a review
Your Review: Note: HTML is not translated!
Rating: Bad Good
Enter the code in the box below: